Shellac and oiled...

Here's the finished piece, shellaced and oiled. I usually screw up a piece when I finish it, but this one turned out ok. I used a 1lb cut of shellac as a sealer, and did a fine sanding with 400 grit. As soon as the shellac went on the walnut really popped. Once the shellac coat was sanded, I applied a coat of Danish Oil. The walnut really came alive. I followed the Danish Oil directions from a Fine Woodworking article, wiping off the excess that seeped out. I ran out of time and had to let it set for a week. The next weekend I applied another coat, again following the Fine Woodworking article directions. This is the result of 1 coat of shellac as a sanding sealer, and 2 coats of Danish oil.

Now all that is left is to apply the shade. I'm not 100% sure how I'm going to do that yet. As of right now, my plan is to cut a piece of material to fit each of the "4 frames" and place the material in the frame without glue. If I have to use glue I will. Any ideas on what material to use or how to attach it would be appreciated.

As for the pictures, I'm no photographer. I do know that over a distance parallel lines will look somewhat curved because of the curvature of a camera lense. So, the curve effect in the full length picture is an optical illusion. Another optical illusion is the bottom stretchers. The angle in the picture is just weird. If there are any other mistakes in the piece, those are optical illusions as well :).

A good shellacing...

The cabinet & legs are drying in the sun at the moment. I did a light sanding of the first coat of shellac on the cabinet and applied the second coat. I put the first coat of shellac on the legs. Like I said, they're drying in the sun right now. I didn't bother with pics, cause that would be like watching shellac dry. The legs looked fine where they had gotten wet. We'll see how it goes when I put on the stain in the next week.

Oh yeah, I've gotten a few toys in the past 2 weeks. I need to take pics an post about them. Maybe later today.

Seal coat part 2...

I just got done doing a light sanding of the first seal coat on the interior of the cabinet. I applied another coat of shellac and made sure to blue tape all the glue surfaces. I forgot to do that on the first coat, so I had to sand those extra. Hopefully tomorrow I can do a light sanding and put some stain on.

Finishing the cabinet...

I'm getting close to assembly for the cabinet, so it is time to start planning the finish. I know since the cabinet is poplar I want a dark finish to hide the green hues. I decided to finish the inside of the cabinet before assembly. I read an article in Fine Woodworking (membership required) about seal coating particular woods so they wouldn't blotch. Woods like, pine, poplar and cherry are notorious for blotching when stained. So, I used a 2lb cut of Zinsser Seal Coat (de-waxed shellac) for the inside of the cabinet. I got the first coat on, and it is ready for a light sanding before the second coat.

I also seal coated a piece of scrap poplar for testing stains. I applied 2 coats of the seal coat, with a light sanding after each coat. I then applied 3 different stains in 3 different sections of the board. Unfortunately, my camera batteries died. When I get batteries I'll post the test piece and let you know which one I chose.